enginehistory.org Forum Index enginehistory.org
Aircraft Engine Historical Society Members' Bulletin Board
 
 FAQFAQ   SearchSearch   MemberlistMemberlist   UsergroupsUsergroups 
 ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in 

Blown engines (not a post about supercharging)
Goto page Previous  1, 2
 
Post new topic   Reply to topic    enginehistory.org Forum Index -> Technical Discussion
View previous topic :: View next topic  
Author Message
rwahlgren



Joined: 15 Aug 2003
Posts: 321

PostPosted: Sun Jan 24, 2010 03:19    Post subject: Reply with quote

jschauer wrote:
A radial engine case is an alunimum forging that would loose it's strength if it was welded.


Wrights use forged steel crank cases.
At least on the ones I have seen as well as in this article
http://www.468thbombgroup.org/LinkClick.aspx?fileticket=sPINPiUsDfI%3D&tabid=36&mid=467
Back to top
View user's profile Send private message
jschauer



Joined: 19 May 2004
Posts: 93
Location: Justin, Texas

PostPosted: Fri Jan 29, 2010 22:29    Post subject: Reply with quote

Going through my references it appears P&W used Aluminum forged cases and CW used steel cases.
Back to top
View user's profile Send private message
Display posts from previous:   
Post new topic   Reply to topic    enginehistory.org Forum Index -> Technical Discussion All times are GMT - 6 Hours
Goto page Previous  1, 2
Page 2 of 2

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum


Powered by phpBB © 2001, 2005 phpBB Group