enginehistory.org Forum Index enginehistory.org
Aircraft Engine Historical Society Members' Bulletin Board
 
 FAQFAQ   SearchSearch   MemberlistMemberlist   UsergroupsUsergroups 
 ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in 

P&W Hornet B Problems

 
Post new topic   Reply to topic    enginehistory.org Forum Index -> Pratt & Whitney Engines
View previous topic :: View next topic  
Author Message
rinkol



Joined: 13 Jul 2003
Posts: 40

PostPosted: Sun Feb 18, 2007 20:25    Post subject: P&W Hornet B Problems Reply with quote

In 1929 P&W increased the bore and stroke of the original Hornet A (1690 cubic inches) to produce the Hornet B (1860 cubic inches). Apparently there were some problems with the Hornet B since P&W reverted to the 1690 cubic inch displacement for all later versions of the Hornet.

Information on the Hornet B seems a bit scarce - can anyone add to this and expand on the reason for the abandonment of the 1860 cubic inch versions?

Robert
Back to top
View user's profile Send private message
gwhite



Joined: 13 Jul 2003
Posts: 58

PostPosted: Tue Feb 20, 2007 13:52    Post subject: Reply with quote

It's my understanding that it suffered from detonation due its larger, over 6", bore. However this begs the question; how did Wright get away with it?
Back to top
View user's profile Send private message
tmartin



Joined: 25 Feb 2012
Posts: 1

PostPosted: Thu Jul 12, 2012 16:21    Post subject: Pratt & Whitney Hornet B Reply with quote

Dear rinkol:
Here's what Herschel Smith and Jack Connors have written in re the Hornet B problems:

Smith, Herschel. Aircraft Piston Engines. New York: McGraw-Hill, 1981, p. 107: "...“…careless throttle handling could cause piston dishing and other problems…”
Connors, Jack. The Engines of Pratt and Whitney: A Technical History.
Reston: American Institute of Aeronautics and Astronautics, 2010, pp. 79-80: “…too close to the upper limits of bore size and the challenge of cooling a cylinder with a minimum of surface area to volume...”

Yours,
Todd Martin
Back to top
View user's profile Send private message
rinkol



Joined: 13 Jul 2003
Posts: 40

PostPosted: Fri Jul 20, 2012 11:41    Post subject: Reply with quote

Todd

Thanks. I have the question of what the definition of "piston dishing" is. One sees the use of the word "dish" in the context of pistons having concave tops. In this case is it referring to erosion from detonation?

Thanks
Robert
Back to top
View user's profile Send private message
Display posts from previous:   
Post new topic   Reply to topic    enginehistory.org Forum Index -> Pratt & Whitney Engines All times are GMT - 6 Hours
Page 1 of 1

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum


Powered by phpBB © 2001, 2005 phpBB Group